Layer Zoom help

This forum is currently in read-only mode.
  • Is it possible to zoom in (x2) on a specific layer at runtime?

    Do I have to use the layer "set zoom offset" action? I tried using that, but no matter what value I put in it it makes the layer 50% of the normal size.

  • Try Construct 3

    Develop games in your browser. Powerful, performant & highly capable.

    Try Now Construct 3 users don't see these ads
  • Is it possible to zoom in (x2) on a specific layer at runtime?

    Do I have to use the layer "set zoom offset" action? I tried using that, but no matter what value I put in it it makes the layer 50% of the normal size.

    Zooming at runtime for individual layers works fine for me. And "set zoom offset" would be the correct action as well. It's the same as the ZoomX/ZoomY properties of the layer. Are you sure that you didnt change the ZoomX/Y RATE properties of that layer unintentionally. Since that could kind of explain things.

    Other than that: share a cap.

  • I was putting in tiny values - when I should have been putting in "200". For some reason when it said ratio values, I thought it would mean small values like 1.5 and 2. LOL

    Thanks for the help!

Jump to:
Active Users
There are 1 visitors browsing this topic (0 users and 1 guests)