Crash at save and close

Link to .capx file (required!):

dropbox.com/s/jytu3kp1s5mfht9/Hex.caproj

Steps to reproduce:

1. Went to save file via floppy icon on top left bar.

Observed result:

Just sits at saving. Says "Saving auto-backup file" on the bottom bar.

Also, no backups were made it seems. I have Construct 2 set to save backups at 15 minute intervals. I had it open for over 40 minutes, and not a single file got saved. I also recall hitting save manually out of habit before hand, and apparently that didn't do anything either.

My folder and administrator privileges are all correct too.

Browsers affected:

Chrome: no

Firefox: no

Internet Explorer: no

Operating system & service pack:

Win8 Pro x64

Construct 2 version:

On release 132 64bit.

A .caproj file is not a full project; please attach a .capx file.

What are your backup locations set to? If they are other drives or network locations or other locations which are not accessible, Construct 2 may get stuck trying to write to them.

A .caproj file is not a full project; please attach a .capx file.

What are your backup locations set to? If they are other drives or network locations or other locations which are not accessible, Construct 2 may get stuck trying to write to them.

Then that's what Construct 2 saved. The only capx file I have of the project is this one which is from my other computer. This file is a day older,and probably about 50 events less

db.tt/UsuIy1r8

And the backup folder is in my documents