I am trying to following an example/modify it to suite my needs. I followed it to the letter, with the exception of the constraints of the parallax. I wanted my bg to move a bit more. However, I am encountering an unusual issue, with my second layer sprite being cut off. I set the layer above to transparent, but even then that layer only has my main character sprite. I have tried adjust the position, adjusting the width, adjusting the scale and various configurations of transparent. At this point, I am not sure what I did wrong.
This is the tutorial i followed: ... ion/page-2
I apologize if this was the wrong place, but I would prefer a answer quickly, as I am learning this to teach some campers about parallax and the tutorial was to high level for them ( and apparently me too ). Therefore, I am on a tight schedule.
Is it the following tutorial you are referring to: https://www.scirra.com/tutorials/314/parallax-effect-with-4-layers-for-construct2-free-edition?
If so, I recommend following it to the letter initially so you end up with a fully working example.
After that, you can experiment away on a copy of your completed tutorial and if it breaks, pleast post a link to it so we can try it for you.
Providing a .capx is always the quickest and most effective way of getting a prompt response, without the need for lots of guesswork.