From the Wiki:

[quote:11n3qrvm]Lerp(a, b, x)

Linear interpolation: Calculates a + x(b - a), or linearly interpolates a to b by x%. Eg. lerp(a, b, 0.25) gives the value 25% of the way from a to b

Basically this is a lot like the game "pick a number between 1 and 10".

Except for here we are using a percent, so our x, or number we are picking must be expressed as a float. IE 50% would be 0.5, and 25% would be 0.25. In which case our return value would be 5.5, and 7.75.

In case you were wondering that would be written as lerp(10, 1, 0.5).

Ok maybe not to terribly useful for that little game, but suppose you had two numbers say something like x coordinates for two different sprites. Then suppose you wanted a third sprite to move somewhere in between the first two sprites, lets say half way.

With lerp all we have to do to find the point that's in the middle of the two is use the expression like this:

```
lerp(sprite1.x, sprite2.x, 0.5)[/code:11n3qrvm]
Of course you might want to find a y value as well:
[code:11n3qrvm]lerp(sprite1.y, sprite2.y, 0.5)[/code:11n3qrvm]
Ok in this example half the way was shown with 0.5, so if we wanted to go 1/4 of the way we would use 0.25, and if we wanted to go 75% of the way we would use 0.75 etc.
Now lets put that together. We have 3 sprites, sprite1, sprite 2, and sprite3. Sprite one is on the left side of the layout, and sprite 2 is on the right side. Then sprite 3 you can place [i]anywhere[/i].
With a simple trigger the event might look something like this:
[code:11n3qrvm]MouseKeyboard: On Left Clicked on Sprite3
```

Sprite3Set position to lerp(Sprite1.X, Sprite2 .X,0.5), lerp(Sprite1.Y, Sprite2.Y,0.5)[/code:11n3qrvm]

Alright now for the next example lets say we want a smooth transition when sprite 3 moves. We can use lerp for this as well. Note since this would be a continuous action you will need some kind of always event, along with the trigger. I'll use mouse is down.

```
MouseKeyboard: Left mouse button is down
```

Sprite3Set position to lerp(Sprite3.X, lerp(Sprite1.X, Sprite2.X, 0.5),1 - 0.05^TimeDelta), lerp(Sprite3.y, lerp(Sprite.y, Sprite2.y, 0.5),1 - 0.05^TimeDelta)[/code:11n3qrvm]

Wait... wut?

To simplify this we have a lerp within a lerp with the first lerp's numbers, or a, and b are our current x,y, and target x,y, then the x could be thought of a step. We use timedelta to make sure there is no frame skip.

The current x,y is expressed as sprite3.x, and sprite3.y since the sprite is always moving while the mouse is down. Then the target x,y, our second lerp, is written like our original example lerp(Sprite1.X, Sprite2.X, 0.5). Finally the step is expressed as 1 - 0.05^TimeDelta. Basically we are moving a tiny percent of the way each tick.

More coming soon.